Table of Contents
Advertisement
Installation procedure
Troubleshooting
If the computer does not start up after you reinstall the base cover assembly, disconnect the ac power
adapter and then reconnect it to the computer.
Memory module
Prerequisite
Before you start, read
Generic Safety and Compliance Notices
Attention: Do not touch the contact edge of the memory module. Otherwise, the memory module might get
damaged.
For access, do the following:
1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 43.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 44.
and print the following instructions.
Chapter 6
.
45
CRU replacement
Advertisement
Table of Contents
