Do you have a question about the NORLAKE IM241WWG/0 and is the answer not in the manual?
Questions and answers
Robert Gary
May 1, 2025
Norlake IM241WWG/0 digital controller manual
1 comments:
Mr. Anderson
May 16, 2025
The manual for the Standex Norlake IM241WWG/0 digital controller includes information on default factory settings, temperature and defrost control, and operation instructions. The controller is located on the front of the unit and is factory set. It controls the temperature and manages defrost cycles by turning off the condensing unit and fan motors, then energizing defrost heaters. The default setting allows four defrosts per day. Separate instructions and a default settings sheet are included with the unit.
Summary of Contents for Standex NORLAKE IM241WWG/0
Page 1
ICE MERCHANDISER Installation, Operation and Maintenance Instructions Model IM241WWG/0 138647...
Page 2
INSPECTION When the equipment is received, all items should be carefully checked against the bill of lading to insure all crates and cartons have been received. All units should be inspected for concealed damage by uncrating the units immediately. If any damage is found, it should be reported to the carrier at once, and a claim should be filed with the carrier.
Page 3
The Ice Merchandiser utilizes a programmable controller to control the temperature and defrost settings. The controller, which is located on the facade of the unit, is factory set. Please see the default settings sheet and separate instructions that are included on the operation of this controller.
Page 4
MAINTENANCE SERVICE AND ANALYSIS GUIDE MALFUNCTION POSSIBLE CAUSE SOLUTION Compressor will not start - 1. Service cord unplugged 1. Plug in service cord no hum 2. Fuse blown or removed 2. Replace fuse 3. Overload tripped 3. Determine reasons and correct 4.
Need help?
Do you have a question about the NORLAKE IM241WWG/0 and is the answer not in the manual?
Questions and answers
Norlake IM241WWG/0 digital controller manual
The manual for the Standex Norlake IM241WWG/0 digital controller includes information on default factory settings, temperature and defrost control, and operation instructions. The controller is located on the front of the unit and is factory set. It controls the temperature and manages defrost cycles by turning off the condensing unit and fan motors, then energizing defrost heaters. The default setting allows four defrosts per day. Separate instructions and a default settings sheet are included with the unit.
This answer is automatically generated