Polaris RZR RS1 2021 Owner's Manual For Maintenance And Safety page 117

BELT REPLACEMENT / DEBRIS REMOVAL
If a belt fails, always clean any debris from the PVT ducting and from the clutch
and engine compartments when replacing the belt.
Failure to remove ALL debris when replacing the belt could result in vehicle
damage, loss of control and severe injury or death.
1. Allow hot components to cool before performing this procedure.
2. Thoroughly clean all debris from the PVT outlet duct
compartment.
3. Remove the nine (9) clutch cover screws
4. Remove all debris from the entire clutch air duct passage.
5. Check for signs of damage to seals on the transmission and engine. If any
seals appear to be damaged, your vehicle requires prompt service. Your
POLARIS dealer can assist.
Belt slip is responsible for creating excessive heat that destroys belts, wears
clutch components and causes outer clutch covers to fail. Switch to low range
while operating at slower speeds to extend the life of the PVT components
WARNING
w
.
TIP
(belt, cover, etc.)
MAINTENANCE
q
and from the engine
115