Download Print this page

SEVERIN Smoothie Mix & Go SM 3739 Instructions For Use Manual page 12

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
power cord, it must no longer be used:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
∙ The appliance should only be placed on a
level surface. Do not allow the housing or
its power cord to come into contact with
open fl ames or any hot surfaces such as
hot-plates.
∙ Do not let the power cord hang free.
∙ Caution: Do not fi t the blade unit onto
the motor unit without a blender jug fi tted.
∙ Do not touch any moving parts during
operation - this can be extremely
dangerous.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Blender jugs
∙ This appliance comes with two blender
jugs and two lids. For practical storage,
the lids may be attached to the base of
the jugs. To close a jug, fi t the lid und
screw it on tight. In that way, the smoothie
can be conveniently stored or carried,
using the handle.
∙ By lifting up the rubber stopper, the
smoothie can be poured out directly from
the jug.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, the blender jugs and the blade unit
must be thoroughly cleaned, as described in
the section Cleaning and care.
12
Short-term operation
The appliance is designed to process
average domestic quantities of food; it
can be operated without interruption for
a maximum of 3 minutes, after which it
should be allowed to cool down to room
temperature.
Safety switch
A special safety switch in the motor unit
ensures that the appliance cannot be
activated unless a blender jug has been
properly fi tted; otherwise, the motor will not
start when the jug is pushed down.
Operation
∙ Cut the ingredients into cubes of about
15 mm and put them into the blender jug.
∙ For best results, the following sequence
should be observed when putting the
ingredients into the jug:
1. liquids
2. fresh ingredients
3. frozen ingredients
4. yoghurt/ice-cream
∙ The jug has a maximum capacity of
600 ml.
∙ Screw the blade unit clockwise onto the
blender jug.
∙ Connect the appliance to the mains.
∙ Turn the jug upside down and fi t it to the
motor unit in such a way that the triangle
symbol on the blade unit is aligned with
the centre arrow mark on the motor unit.
∙ Pulse operation:
Pushing down on the jug activates the
pulse function until it is released again.
Ensure, however, that the jug is lifted
enough from the motor unit (3) to prevent
any undue wear on the connection
between the motor and blade units.

Advertisement

loading