Advertisement
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Guardian ZDA4-DC1-C12E
- Page 1 Guardian Charging Station EU Standard User manual...
-
Page 2: Table Of Contents
Contents: ......1 Safety Precautions ........2 Packing List ......3 Product Features ......4 Installation Notes ......4 Installation Process ......7 Operation Instruction .......8 Troubleshooting ..9 Warranty, Repair & Maintenance... -
Page 3: Safety Precautions
Safety precaution： 1.Please read the instruction manual carefully before use. Failure to observe the precautions can cause serious bodily harm and injury. 2. Please do not dismantle the product, incorrect assembly may cause product damage, leakage, and water seepage. 3. The installation and maintenance of the charger must be done by a competent electrician;... -
Page 4: Packing List
Packing list : Please check the content inside the box. Products and contents of the box: Charging Station, charging card, （Select Configuration） user manual certificate of conformity... -
Page 5: Product Features
Product Features: General Specifications ZDA4-DC1-C12E/ZDA4-DC1-C11E Model Mode 3 Charging Mode Dimension 310×210×90mm （without cable） 3.5kg Weight Operating Temperature -20 ºC to 50 ºC Storage Temperature -40 ºC to 85 ºC Working Altitude ≤2000m Certifications IEC 61851-1, IEC 61851-22, IEC 62196-2 Electrical Specifications... -
Page 6: Installation Notes
Installation Notes: The installation should consider the following conditions: 1. The location selection should consider the length of cable and provide the user with convenience for charging; 2. Charging equipment should not be installed near hazardous area such as electrical shock and flammable or explosive materials; 3. - Page 7 2.Installation steps: a.Please confirm the installation position and mark it. The central position of the charging pile should be at least 1.3 meters above the ground. The Wall 1.3M b. Compare the four locating holes on the hanging plate, and mark the wall with Ф...
- Page 8 2.Installation steps: d.Connect the power line in sequence at the wiring on the back of the charging pile. Dual-phase Single-phase wiring diagram wiring diagram Wire Junc�on e. Hang the charging pile installed with the incoming line on the hang- ing plate, lock the charging pile and the hanging plate with two M4 * 6 cross recessed pan head screws on both sides of the charging pile, and the installation is completed.
-
Page 9: Operation Instruction
Operation Instruction: Start charging Before charging, the charging cable and connector should be inspected for damage, without foreign objects, water ingress or impurities. Connect charging pile and vehicles The light strip turns into a green light in slowly flashing , then wait starting. Swipe the card to charge We use an RFID card to start charging by putting it close to the swipe area. -
Page 10: Troubleshooting
Troubleshooting： Note: Below faults should be tested and diagnosed by professional electricians. We take no responsibility for any damage or safety hazards caused by operation by non-professional person. User Operation Error Cause Indicator Status Leakage Red light flashes 1 time Contact the Customer Service CP Error Red light flashes 2 times... -
Page 11: Warranty, Repair & Maintenance
Warranty, Repair & Maintenance ： Please refer to your local authorized representative for country specific warranty terms. There are no user serviceable parts inside the charging equipment. Please contact the authorized service provider for assistance. Disclaimer： 1. Accidental damage during transportation of the product by the customer. 2.
Need help?
Do you have a question about the ZDA4-DC1-C12E and is the answer not in the manual?
Questions and answers
Hi. We have just had our charging station installed. Is there an APP so I can set a timer?
Is there an app so i can vary the current output from 6amp to 32a e.g 1.3kw to 7kw