Wall Mount Kit Specifications (Vesa) - Samsung QHH Series User Manual

Wall Mount Kit Specifications (VESA)

― Install your wall mount on a solid wall perpendicular to the floor. Before
attaching the wall mount to surfaces other than plaster board, please
contact your nearest dealer for additional information.
If you install the product on a slanted wall, it may fall and result in
severe personal injury.
• Samsung wall mount kits contain a detailed installation manual and all parts necessary for assembly are
provided.
• Do not use screws that are longer than the standard length or do not comply with the VESA standard screw
specifications. Screws that are too long may cause damage to the inside of the product.
• For wall mounts that do not comply with the VESA standard screw specifications, the length of the screws may
differ depending on the wall mount specifications.
• Do not fasten the screws too firmly. This may damage the product or cause the product to fall, leading to
personal injury. Samsung is not liable for these kinds of accidents.
• Samsung is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is
used or the consumer fails to follow the product installation instructions.
• Do not mount the product at more than a 15 degree tilt.
• Always have two people mount the product on a wall.
• Standard dimensions for wall mount kits are shown in the table below.
Model name VESA screw hole specs (A * B)
in millimetres (inches)
DBJ 200 × 200 (7.9 × 7.9)
QBH / QHH / QMH 400 × 400 (15.7 × 15.7)
― Do not install your Wall Mount Kit while your product is turned on. It may result in personal injury due to electric
shock.
― If you want to use a wall mount, make sure that it allows you to remove the product from it without using any
additional tool. (Supported models: DBJ)
Standard Screw Quantity
M8 4
29