Table of Contents
Advertisement
d
b
c
Repeat steps
and
with a weeding box.
The weeding box is created.
a Weeding box
Memo
• The data for a created weeding box is saved on a layer
separate from that for the pattern data.
for each object that will be cut
Exporting Data as FCM File
Save data as an FCM file on a computer or USB flash drive, and
then use a USB flash drive to transfer the data to the cutting
machine.
For details on transferring data directly from
CanvasWorkspace to a cutting machine, see "Sending Data
a
to the Machine" on page 8.
■ Saving to a USB Flash Drive
a
Plug the USB flash drive into a USB port on the computer.
b
In CanvasWorkspace, select [Export/Transfer FCM File]
from the [File] menu.
Note
• In order to export data for a roll feeder, [Rolled Material]
must have been selected under [Artboard Size] when the
data was edited. Before exporting the data, recheck this
setting. For details, see "Creating Data" on page 4.
c
Select [Export FCM File].
d
Select [USB Drive (*)] as the destination, and then click
[Save].
*
This designation differs depending on the operating system
being used.
The data is saved as an FCM file on the USB flash drive.
7
Advertisement
Table of Contents
