Table of Contents
Advertisement
Surface burner
Problem
Possible cause
All burners do
The power cord is
not light.
not plugged into the
electrical outlet.
A fuse in your home
may be blown or a
circuit breaker may
have tripped.
The gas supply is not
properly connected or
turned on.
A surface
The control knob is not
burners do not
set properly.
light.
The burner caps are not
in place.
The burner base is
misaligned.
A surface
The control knob has
burner
been left in the LITE
clicks during
position.
operation.
The burners do
The surface burner
not burn evenly.
components and caps
are not assembled
correctly and level.
The surface burners are
dirty.
Very large or
The wrong burner
yellow surface
orifice is installed.
burner flames.
NX58N3315SS_AP_DG68-00773B-01_EN.indd 25
Action
Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the circuit
breaker.
See the Installation Instructions that
came with your range.
Push in the control knob and turn it
to the LITE position.
Clean the electrodes.
Put the burner cap on the burner
head.
Align the burner base.
After the burner lights, turn the
control knob to a desired setting.
If the burner still clicks, contact a
service technician.
See page 21.
Clean the surface burner
components. (See page 21.)
Check the burner orifice size and
contact your installer if you have
the wrong orifice.
Problem
Possible cause
The surface
The oven door lock is
burners light
turned on.
but oven
burners do not
light.
The Gas Pressure
Regulator shut off
switch is in the off
position.
Oven
Problem
Possible cause
The oven control
There may be a
beeps and displays
malfunction. See the
an information
"Information codes" chart
code.
on page 27.
Very large or
The oven burner air
yellow oven
adjustment shutters need
burner flames.
to be adjusted.
The gas supply is not
properly connected or
turned on.
The oven
The oven thermostat needs
temperature is too
adjustment.
hot or cold.
Action
The display will show the Lock
icon. Hold the oven door open and
press the START/SET button for
3 seconds. The oven will beep and
the Lock icon will turn off.
Call a qualified service technician.
Action
Press the OFF/CLEAR button and restart
the oven.
If the problem persists, disconnect
all power to the range for at least
30 seconds, and then reconnect the power.
If this does not solve the problem, call for
service.
Call for a qualified service technician.
See the Installation Instructions that came
with your range.
See page 19.
English 25
2020-06-18 오후 5:16:22
Advertisement
Table of Contents
