Table of Contents
Advertisement
Important instructions regarding safety and environment
• The plug shall be easily accessible. If this is not
possible, a mechanism that meets the electrical
legislation and that disconnects all terminals
from the mains (fuse, switch, main switch, etc.)
shall be available on the electrical installation.
• Do not touch the plug with wet hands.
• When unplugging the appliance, don't hold the
power cord, but the plug.
• When positioning the appliance, ensure the
supply cord is not trapped or damaged
• Do not locate multiple portable socket-outlets
or portable power supplies at the rear of the
appliance.
• When positioning the appliance, ensure the
supply cord is not trapped or damaged
• Do not locate multiple portable socket-outlets
or portable power supplies at the rear of the
appliance.
1.4 Handling Safety
• This product is heavy, do not handle it by your-
self.
• Do not hold the product from its door while han-
dling the product.
• Be careful not to damage the cooling system
and the pipes while handling the product. Do
not operate the product if the pipes are dam-
aged, and contact an authorized service.
1.5 Installation Safety
• Contact the Authorized Service for the product's
installation. To prepare the product for installa-
tion, see the information in the user guide and
make sure the electric and water utilities are as
required. If the installation is not suitable, call a
qualified electrician and plumber to have them
make the necessary arrangements. Otherwise,
electric shock, fire, issues with the product or
injuries may occur.
• Check for any damage on the product before
installing it. Do not have the product installed if
it is damaged.
• Place the product on a level and hard surface
and balance with the adjustable legs. Otherwise,
the refrigerator may tip over and cause injuries.
• The product shall be installed in a dry and ven-
tilated environment. Do not keep carpets, rugs
or similar floor covers under the product. This
may cause risk of fire as a result of inadequate
ventilation!
• Do not block or cover ventilation holes.
Otherwise, power consumption may be in-
creased and damage to your product may
occur.
• Do not connect the product to supply systems
such as solar power supplies. Otherwise, dam-
age to your product may occur as a result of
the abrupt voltage fluctuations!
• The more refrigerant a refrigerator contains,
the bigger its installation room shall be. In
very small rooms, a flammable gas-air mixture
may occur in case of a gas leak in the cooling
system. At least 1 m³ of volume is required for
each 8 grams of refrigerant. The amount of the
refrigerant available in your product is specified
in the Type Label.
• The installation place of the product shall not
be exposed to direct sunlight and it shall not be
in the vicinity of a heat source such as stoves,
radiators, etc.
If you cannot prevent installation of the product in
the vicinity of a heat source, you shall use a suit-
able insulation plate and the minimum distance to
the heat source shall be as specified below.
- At least 30 cm away from heat sources such
as stoves, heating units and heaters, etc.,
- And at least 5 cm away from electric ovens.
• Your product has the protection class of I. Plug
the product in a grounded socket that con-
forms with the Voltage, Current and Frequency
values specified in the type label. The socket
outlet shall be equipped with a fuse with a
rating of 10 A – 16 A. Our company shall not
be responsible for the damages that shall be
incurred as a result of operating the product
without ensuring ground and electrical connec-
tions made as per local or national regulations.
• The product's power cable must be unplugged
during installation. Otherwise, risk of electric
shock and injury may occur!
• Do not plug the product to loose, broken, dirty,
greasy sockets or sockets that has come out
their seats or sockets with a risk of water con-
tact.
4 / 37 EN
Refrigerator / User Manual
Advertisement
Table of Contents
