Sony CECH-4008A Manual page 8

inside the PS3™ system (The hard disk drive may be removed
and replaced but may not be disassembled or modified.).
Additionally, there is a risk of exposure to laser radiation as well
as to electrical shock.
Network
• A broadband Internet connection is required to connect to a
network.
• User is responsible for Internet service fees. For details, refer
to the information provided in your service contract or contact
your Internet service provider.
• Use only an Ethernet cable compatible with 10BASE-T,
100BASE-TX or 1000BASE-T networks. Do not use a cord for
a standard residential telephone line or cables of types other
than those mentioned here. Using the wrong type of cord or
cable can cause more electrical current than necessary to
flow through the LAN connector, which may lead to heat
build-up, fire or malfunction.
Wireless networking feature
• The 2.4 GHz range of radio waves used by the wireless
networking feature of this product is a range shared by
various devices. This product has been designed to minimise
the effect of other devices using the same range. However, in
some cases interference from other devices may reduce the
connection speed, shorten the signal range or cause the
connection to be terminated unexpectedly.
• When using the PS3™ system's scan function to select a
wireless LAN access point, access points that are not
intended for public use may be displayed. Only connect to an
access point that you are authorised to use, or one that is
available through a public wireless LAN or hotspot service.
8
Moisture condensation
If the system or disc is brought directly from a cold location to a
warm one, moisture may condense on the lens inside the
system or on the disc. Should this occur, the system may not
operate properly. In this case, remove the disc and turn off and
unplug the system. Do not put the disc back in until the moisture
evaporates (this may take several hours). If the system still does
not operate properly, contact the appropriate PlayStation
customer service helpline which can be found within every
PlayStation 3 software manual.
®
Protecting the lens and the surrounding area
Do not touch the lens located inside the disc cover or any of the
parts around the lens. To help protect the lens from dust, keep
the disc cover closed except when inserting or removing discs.
If the lens is dirty, or if you touch the parts around the lens, the
system may not operate properly.
Cleaning
For safety reasons, before cleaning the system or connected
accessories, disconnect the AC power cord from the electrical
outlet.
Exterior surfaces (plastic cover of system and Wireless
Controller)
Follow the instructions below to help prevent the product
exterior from deteriorating or becoming discoloured.
• Wipe with a soft, dry cloth.
• Do not apply insecticides or other volatile substances.
®