Table of Contents
Advertisement
4. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the I/O-board cable to the I/O board.
6. Close the latch and replace the clear adhesive tape.
7. Connect the fingerprint-reader cable to the I/O board and close the latch to secure the cable.
8. Align the screw holes on the RJ45 network-port assembly with the screw holes of the I/O board.
9. Replace the three screws (M2x5) that secure the RJ45 network-port assembly to the I/O board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
I/O
board.
About this task
NOTE:
Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the power button with optional fingerprint reader and provides a visual
representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
37
Advertisement
Table of Contents
