Dell Vostro 5630 Service Manual page 62

Table 9. System setup options—Power menu (continued)
Power
Wake on Dell USB-C Dock
Block Sleep
Lid Switch
Enabled Lid Switch
Power On Lid Open
Intel Speed Shift Technology
Table 10. System setup options—Security menu
Security
TPM 2.0 Security
TPM 2.0 Security On
Attestation Enable
Key Storage Enable
SHA-256
Clear
PPI Bypass for Clear Commands
SMM Security Mitigation
Data Wipe on Next Boot
62 System setup
NOTE: This feature requires Deep Sleep Control to be disabled.
NOTE: This feature is only functional when the AC power adapter is
connected. If the AC power adapter is removed before Standby, the BIOS
will remove power from all of the USB ports to conserve battery power.
By default, the Enable USB Wake Support option is disabled.
When enabled, connecting a Dell USB-C Dock will wake the system from
Standby, Hibernate, and Power Off.
By default, the Wake on Dell USB-C Dock option is enabled.
Enables to block entering sleep (S3) mode in the operating system.
By default, the Block Sleep option is disabled.
Enable or disable the lid switch.
By default, the Enable Lid Switch option is enabled.
When enabled, allows the system to power up from the off state whenever the
lid is opened.
By default, the Power On Lid Open option is enabled.
Enable or disable the Intel speed shift technology support.
By default, the Intel Speed Shift Technology option is enabled.
Allows you to enable or disable TPM visibility to operating system.
By default, the TPM 2.0 Security On option is enabled.
Enables to control whether the Trusted Platform Module (TPM) Endorsement
Hierarchy is available to the operating system.
By default, the Attestation Enable option is enabled.
Enables to control whether the Trusted Platform Module (TPM) Storage
Hierarchy is available to the operating system.
By default, the Key Storage Enable option is enabled.
When enabled, the BIOS and TPM will use the SHA-256 hash algorithm to
extend measurements into the TPM PCRs during BIOS boot.
By default, the SHA-256 option is enabled.
Enables to clear the TPM owner information and returns the TPM to the
default state.
By default, the Clear option is disabled.
Controls the TPM Physical Presence Interface (PPI).
By default, the PPI ByPass for clear Commands option is disabled.
Enable or disable additional UEFI SMM Security Mitigation protections.
By default, the option is enabled.