Names Of Parts And Components, Turning On The Power - Sharp MX-2610N Quick Start Manual

NAMES OF PARTS AND COMPONENTS, TURNING ON THE POWER

This machine has a main power switch, found at the
bottom left after the front cover is opened, and a power
button ( ), located on the operation panel.
Turning on the power
• Switch the main power switch to the "
The main power indicator will light in orange. The
power button ( ) does not function while the main
power indicator is lit in orange.
• After the main power indicator lights in green, press
the power button ( ).
Turning off the power
(1) Press the power button ( ) to turn off the power.
(2) Switch the main power switch to the " " position.
Restarting the machine
In order for some settings to take effect, the machine
must be restarted. If a message in the touch panel
prompts you to restart the machine, press the power
button ( ) to turn off the power and then press the
key again to turn the power back on.
CAUTION
• When turning off the power, make sure that the indicators on the
operation panel turn off as well.
• If the machine suddenly turns off, such as in the event of a power failure,
turn the machine on again, and then turn off the machine following the
correct procedure for turning off the machine.
Switching off the main power switch or removing the power cord from the
outlet while any of the indicators are lit or blinking may damage the hard
drive and cause data to be lost.
• Switch off both the power button (
unplug the power cord if you suspect a machine failure, if there is a bad
thunderstorm nearby, or when you are moving the machine.
12
Main power
indicator
" position.
Power button
Main power switch
Saddle Finisher*
) and the main power switch and
Output tray (Center tray)
Keyboard*
Automatic
document feeder
• When using the fax or Internet fax function, always keep the main power switch
in the " " position.
• In some states of the machine, pressing the power button (
make the settings take effect. In this case, use the main power switch to switch
the power off and then on.
Operation
panel
Right tray
Paper pass unit*
Bypass tray
Front cover
Tray 5
(when a large capacity tray is installed)*
Tray 1
Tray 2
(when a paper feed tray is installed)*
Tray 3
(when a paper feed tray is installed)*
Tray 4
(when a paper feed tray is installed)*
) to restart will not
Finisher*
* Optional