Table of Contents
Advertisement
ESC4000 G4S
For the ESC4000 G4S, the NVME drives may be installed in HDD bay 7 and 8 as shown in
the illustration below:
To install a U.2 drive:
1.
Install the U.2 drive to HDD bay 7 or 8.
Refer to section 2.4.2 Installing the 2.5-inch SSD for the steps on installing a 2.5-inch
drive to the HDD bay.
2.
Remove the OCuLink cables from the internal SAS/HBA/Storage bracket.
OCuLink cable 2
OCuLink cable 1
2-44
HDD bay 7 and 8
Chapter 2: Hardware Setup
2
1
Advertisement
Table of Contents
