Levelling The Appliance - LG WT1310BRK Owner's Manual

INSTALLATION
22
band clamp to keep the washer hose in
a
place.
3
Use the band clamp
to attach it to the bottom opening of the drain
hose connector.
4
Securely connect the short drain hose to a
drain spigot, into a standpipe or laundry sink
bypass pipe.
When connecting to a waste spigot, use the
band clamp to the end of the short drain
c
hose.
on the short drain hose
b
CAUTION
• Adjust the wire hose clamp to prevent the hose
from coming loose or leaking. Failure to do so
could result in flooding. Use of the drain hose
connector helps avoid siphoning, odours, or
improper draining.
• Make sure the drain hoses are not kinked or
pinched. This is a potential cause of drainage
problems or noise.

Levelling the Appliance

Checking the Level
When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions).
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
• Check whether the appliance is perfectly level
after installation.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and unbalance.
Reinforcement or bracing of the timber floor
may need to be considered to stop or reduce
excessive noise and vibration.
Adjusting and Levelling the
Feet
When installing the appliance, the appliance
should be aligned and perfectly level. If the
appliance is not aligned and level properly, the
appliance may be damaged or may not operate
properly.
1
Turn the levelling feet as required if the floor is
uneven.
• Do not insert pieces of wood etc. under the
feet.