Headphones - Sharp HT-DD5000 Operation Manual

(Continued)
1
2
3

HEADPHONES

The tuner and any components that are connected to the
DVD, VCR-1, VCR-2, CD/AUX, MD/TAPE or PHONO jacks
can be turned off automatically.
1
2
3
2 3 4
4
5
To check the remaining sleep time:
Press the TIMER/SLEEP button twice.
To cancel the sleep operation:
Press the POWER button to turn the power off.
Notes:
1
2
Note:
24
HT-DD5000(SEC) TINSE0009SJZZ
Sleep operation
Play back the desired sound source.
Press the TIMER/SLEEP button repeatedly until "SLEEP"
is displayed.
Turn the jog dial to set the sleep time.
The maximum sleep time you can specify is 2 hours, in
5-minute intervals.
OFF 5 10 ............ 1:55
Press the ENTER button.
The unit will turn off automatically after the preset sleep
time has elapsed.
When it is one minute before the sleep-off time, the vol-
ume will start to fade.
After the sleep operation has finished, the sleep setting
time will be canceled. If you want to set the sleep oper-
ation again, start from the beginning of this procedure.
The sleep operation cannot control any components that
are connected to the DVD, VCR-1, VCR-2, CD/AUX,
MD/TAPE or PHONO jacks.
Before plugging in or unplugging the headphones, make
sure the volume level is reduced.
Be sure your headphones have a 1/4" (6.3 mm) diameter
plug and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
Set the SPEAKERS A and B button to OFF.
When headphones are connected, adjust the VOLUME
control for the desired volume.
When using headphones, it is recommended that you se-
lect STEREO in the Dolby Surround mode.
2:00