Select Programme; Wash Cycle; Maintenance And Care; Switch Off Appliance - Whirlpool ADG 8210 Quick Reference Manual

Select programme

Quick, permanent or alternating
6
Overview of programmes
The max. possible number of programmes is illustrated in the chapter "Chart". The corresponding programmes for your appliance can be found on the panel (page 1).
Choose programme according to the attached table of programmes (page 1).
Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.

Wash cycle

7
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Beware of hot steam!
Close the door again.
The programme resumes the cycle from where it was interrupted.
The wash cycle can be interrupted at any time by pressing RESET (see chapter "What to do if...").
Switch off the appliance Everything o.k. ...
8
Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.

Maintenance and care

9
Filters
Check and
clean if
necessary
Rectifying minor faults yourself ...
10
Spray arms
Remove
blockages/
deposits.
Unscrew filter
cylinder, remove it
and fine sieve...
Unscrew
and remove
lower arm ...
Change the programme in progress:
• Press the RESET button.
• Close the door.
• (Water drains for up to 60 seconds).
• Open the door.
• Select a new programme.
• Press the START button.
Rinse under running
water ...
Unscrew
and remove
upper arm ...
Maintenance and care
Screw on filter cylinder NOTE MARK!
Insert
Insert and screw on lower and upper arms tightly.
Clean spray
nozzles under
running water
(use toothpicks if
necessary) ...
GB -5-