Select Programme; Maintenance And Care - Whirlpool ADG 6550 Quick Reference Manual

Table of Contents

Advertisement

Select programme

Quick, permanent or alternating
6
Overview of programmes
The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the panel (page 1).
Choose programme according to the attached table of programmes (page 1).
Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
Wash cycle
7
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Beware of hot steam!
Close the door again.
The programme resumes the cycle from where it was interrupted.
The wash cycle can be interrupted at any time by pressing RESET (see chapter "What to do if").
Switch off the appliance Everything o.k. ...
8
Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.

Maintenance and care

9
Filters
check and
clean if
necessary
Rectifying minor faults yourself ...
10
Spray arms
Remove
blockages/
deposits.
Rotate filter
cylinder, remove
filter system ...
Pull
lower arm
upwards ...
Rinse under
running water ...
Unscrew
upper arm ...
Change the programme in progress:
• Press the START button (for 2 seconds) until the START indicator lamp
switches off.
• (Water drains for up to 60 seconds).
• Select a new programme
• Press the START button.
Maintenance and care
Insert
Insert lower arm ...
Clean spray
nozzles under
running water
(use toothpicks
if necessary) ...
Screw on filter
system
NOTE MARK!
Screw on upper arm tightly
GB -5-

Advertisement

Table of Contents
loading

Table of Contents