Replacing The Keyboard - Lenovo IdeaCentre Q200 Hardware Maintenance Manual

Replacing the keyboard

5. Ensure the adapter is fully seated into the adapter connector.
6. Pivot the adapter latch to the closed position to secure the adapter.
7. Refer to the "Completing the installation".
Attention
Do not remove the computer cover or attempt any repair before
reading the "Important safety information" in the Safety and Warranty
Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of
the Safety and Warranty Guide or HMM, go to the Support Web site at
http://consumersupport.lenovo.com.
To replace the keyboard:
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut
down your operating system, and turn off all attached devices and the
computer.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the keyboard. Refer to "Locating connectors
on the rear of the computer" and "Locating connectors on the front of
the computer".
Note: Your keyboard might be connected to the standard keyboard
connector at the rear of the computer or to a USB connector
either the front or rear of the computer.
Chapter 7. Replacing hardware
at
47