Boot Pin Modification - We TARVOS-III Migration Manual

WIRELESS CONNECTIVITY & SENSORS
ANR022 - Radio module cross migration guide
In case, the BOOT pin is hardwired to ground on the sub-GHz proprietary
module, a replacement by the Thyone-I is not possible, as the Thyone-I would
always start in boot mode.
If the Boot pin is hardwired on the Host PCB, adapter board design shall be modified by inte-
grating an inverter IC on the BOOT pin of the Thyone-I module.
Version 1.1, July 2023
Figure 12: Boot pin modification
www.we-online.com/wcs
21