Medisana IPL 850 Instruction Manual page 45

WARNING
• Never emit several light pulses in succession onto the same
area of skin!
• If pain, swelling or other unusual reactions occur during the
application, immediately stop the test and do not carry on
using the device. Contact your doctor.
4.5 The display of IPL 850 features two lines. First/upper line ("Energy") shows in-
Display / tensity and readiness (flashing or non flashing number). Second line ("Flash")
Intensitiy shows the number of emitted flashes. It will refesh every 1,000 flashes. Here
display
a value of "001" stands for 1000 flashes. If the number of flashes passes
"180" (180,000) the display will show
That means: The cartridge will soon be depleteted and needs to be replaced.
(- > chapter 5.2 Replacing the cartridge)
While transferring the device to other skin areas you can proceed in two different ways:
Method 1: "Gliding and flashing"
Keep the trigger button
cession as long as the light area
pulse slide the device to the next area. Keep the light area
skin. This mode is especially suited to treating larger areas, such as the legs, for
example.
Method 2: "Stopping and flashing"
Release the trigger button
tion the device on the area directly next to the area that has just been treated.
Make sure that the light area
skin. This mode guarantees precise treatment for example of the knees or ankles.
WARNING
If a device fan fault should occur during the application, immediately
stop use of the device, otherwise skin injuries may be caused by the high
heat. Contact the customer service.
pressed down. The device emits a light pulse in suc-
8
is in full contact with the skin. After each light
5
after each light pulse. For the next light pulse posi-
8
and the skin contact sensors
5
4 Operating
pressed onto the
5
lie fully on the
4
GB
45