Charging The Battery (For Bc Version Only - RCm BIT 391CB Use And Maintenance

EN
4.1 CHARGING THE
BATTERY
(for BC version only)
DANGER:
Charge the batteries in well-ventilated ar-
eas which comply with standards in force
in the country of use.
For safety-related information, follow what
is described in chapter 1 of this manual.
WARNING:
For information and warnings about the
battery and the battery charger, follow
what is described in the battery and bat-
tery charger manual enclosed with this
document.
- Move the machine to the vicinity of a main
electrical socket.
- Remove the cable from the kit (2) and
connect it to the socket (3) on the ma-
chine then connect the other end to the
mains socket.
WARNING:
Check that the mains voltage is compat-
ible with the operating voltage of the bat-
tery charger (110 - 250 V, 50/60 Hz).
- Leave the batteries to charge until the
"Green" LED (4) comes on, then remove
the power cable (2) and put it back in po-
sition.
N.B.:
10 hours are needed for complete battery
charging.
Avoid partial recharges.
(Fig. 6)
EN-10
1
2
3
4
Fig. 6