LG WF-HX120GV/01 Service Manual page 9

2-3. CONNECT THE DRAIN HOSE
▒ For pump model
•
Connect the drain hose to
the outlet of the drain pump
located at the rear of the
washing machine.
● NOTE : • Never lay down the drain hose, as water will be discharged.
• Be sure the drain hose is properly routed so it will not kink or lift from the sink.
• The discharge height should be approximately 0.9~1.2m from the floor.
• Connect the drain hose adjusting the length of it not to be dropped. If drain hose is dropped the
drainage could be poor because of blockage in the hose.
▒ For non - pump model
• Connect the drain hose to the outlet of the drain
located at the back side of the washing machine.
• Keep it downward while the washing machine is working.
• Ensure the hose is free from kinking.
•
Attach the clip to the drain
hose. And then push it
toward the body of the
washing machine as
indicated by the arrow.
• Do not install the washer where it is directly exposed to sunlight,
wind, rain etc.
• Plug the power cord of this washer into a properly installed
standard electrical outlet that is switched & earthed.
• Check that the drain hose is
hung up over the edge of the
laundry tub.
• Do not use an extension hose.
0.9~1.2m
• Fix the drain hose with the clip.
And then push it toward the body as in the figure.
9
Hose
Guide
Drain Hose