LG F1 U1 BS Series Service Manual page 22

ERROR
8 MOTOR LOCKED
ERROR
9
POWER
FAILURE
10 NFC MODULE
ERROR
11 NFC VERSION
ERROR
SYMPTOM
• The connector in the LEAD WIRE ASSEMBLY is
not connected to the connector of STATOR
ASSEMBLY.
• The hall sensor is out of order/defective.
• The washer experienced a power failure
• The connector in the DISPLAY PCB ASSEMBLY
is not connected to the connector of
NFC PCB ASSEMBLY.
• The NFC HARNESS between the NFC PCB
ASSEMBLY and DISPLAY PCB ASSEMBLY is cut
(open circuited).
• The NFC PCB ASSEMBLY is out of order/defective.
* nC is displayed only in the first screen of the Load
Test Mode.
• NFC version is not matched.
* nU is displayed only in the first screen of the Load
Test Mode.
CAUSE
Reconnect or repair the connector.
Replace the STATOR ASSEMBLY
Press the start/pause button
Reconnect or repair the connector.
Replace the DISPLAY PCB ASSEMBLY.
Replace the NFC PCB ASSEMBLY.
Replace the NFC PCB ASSEMBLY.
Page 36