Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for eltherm ELTC-21
Summary of Contents for eltherm ELTC-21
- Page 1 OPERATION- MANUAL ELTC-21 & ELTC-22 Temperature controller up to 400°C for DIN rail mounting eltherm GmbH P.: +49 2736 4413-0 BU-093 F.: +49 2736 4413-50 Ernst-Heinkel-Strasse 6 -10 Revision 7 57299 Burbach, Germany info@eltherm.com www.eltherm.com...
- Page 2 PARAMETERS AND THEIR MEANING Notes on commissioning Declaration of Conformity DOWNLOADS NOTES For proper and safe use of the ELTC-21 and ELTC-22 tempe- rature controller, please follow these instructions. Please keep these instructions for future reference (e.g. in the system documentation). RESERVATION Subject to technical changes.
- Page 3 For more information on the disposal and recovery of waste electrical and electronic equipment (WEEE) and collection points, please contact your local waste management com- pany or the manufacturer from whom you purchased the product. Contact us: +49 2736 4413-0 • info@eltherm.com www.eltherm.com...
- Page 4 In the event of sensor errors, relay K1 switches the heating line off or on, depending on the configuration of the controller. TECHNICAL DATA Controller type ELTC-21 ELTC-22 Nominal voltage 187…253 VAC, 50/60 Hz 24 VDC / 18 VAC, ± 10 % Current consumption max.
- Page 5 NOTE After switching on the controller, the display shows the current actual value. Contact us: +49 2736 4413-0 • info@eltherm.com www.eltherm.com...
- Page 6 OPERATION OPERATING PANEL LEDs in Display 1st"." = Control relay ON 2nd"." = Alarm relay activated (=switched OFF) A flashing of the LEDs indicates a function delay. Keys " " = Increase values " " = Decrease values "P" = Programming key Protection against unauthorized operation The control setpoints can basically be set without restriction, After switching on, the type number ("C-2") and software...
- Page 7 4 = Relay K2 (passive) drops in case of sensor error Load relay K1 energizes in case of sensor error 5 = K2 works as enable relay Load relay K1 energizes in case of sensor error Contact us: +49 2736 4413-0 • info@eltherm.com www.eltherm.com...
- Page 8 DOWNLOADS You can find helpful downloads for this or other products under the following link: https://eltherm.com/downloads NOTES Parameter Own settings eltherm GmbH Headquarters Ernst-Heinkel-Straße 6 -10 57299 Burbach. Germany T.: +49 2736 4413-0 F.: +49 2736 4413-50 info@eltherm.com www.eltherm.com...
Need help?
Do you have a question about the ELTC-21 and is the answer not in the manual?
Questions and answers