Hisense CFU14N6AWE User's Operation Manual page 15

15
A layer of frost occurs in
the compartment
Temperature inside is
too warm
Temperature inside is
too cold
Doors can't be closed
easily
The light is not working
Freezer door is so hard to
open
Temperature setting is set colder than necessary
Large quantity of warm food has recently been stored within the
appliance.
The temperature outside the appliance is high.
Doors are kept open too long or too often.
After installing the appliance or it has been switched off for a
long time.
Check that the air outlets are not blocked by food and ensure food
is placed within the appliance to allow sufficient ventilation.
Ensure that door is fully closed. To remove the frost, please refer
to the"Cleaning and Care" chapter.
You may have left the doors open too long or too frequently; or
the doors are kept open by some obstacle; or the appliance is
located with insufficient clearance at the sides, back and top
Increase the temperature by following the "Display Controls"
chapter.
Check whether the top of the refrigerator is tilted back by about
10mm to allow the doors to self-close, or if something inside is
preventing the doors from closing.
The LED light may be damaged. Refer to replace LED lights
in" Cleaning and Care" chapter.
The control system has disabled the lights due to the door being
kept open too long. Close and reopen the door to reactivate the
lights.
Warm air inside the freezer compartment is rapidly cooled.
Since cold air takes up less space than warm air, negative
pressure results.
Typically, within a few minutes the pressures of the door will
equalize and the door can be opened with little effort.