Cleaning And Care - Hisense CFU14N6AWE User's Operation Manual

12

Cleaning and Care

For hygienic reasons the appliance
(including exterior and interior accessories)
should be cleaned at least every two
months.
Warning!
To avoid electrical shock, the appliance
must not be connected to the main power
supply during cleaning. Before cleaning,
switch the appliance off and remove the
plug from the main socket.
Exterior cleaning
To maintain good appearance of your
appliance, you should clean it regularly.
Spray water onto a cleaning cloth instead
of spraying directly on the surface of the
appliance. This helps ensure an even
distribution of moisture to the surface.
Clean the doors, handles and cabinet
surfaces with a mild detergent and then
wipe dry with a soft cloth.
Caution!
Don't use sharp objects to clean with, as
they are likely to scratch the surface.
Don't use Thinner, Car detergent, bleach,
ethereal oil, abrasive cleansers or organic
solvent such as Benzene for cleaning. They
may damage the surface of the appliance
and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when food
stocks are low. Wipe the inside of the fridge
freezer with a weak solution of backing soda
and water, and then rinse with warm water
using a wrung-out sponge or cloth. Wipe
completely dry before replacing the shelves
and baskets. Thoroughly dry all surfaces
and removable parts before putting them
back into place.
Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long. If the frost is too thick,
choose a time when the freezer is nearly
empty and proceed as follows:
1. Remove existing food and accessories
baskets, unplug the appliance from the main
power and leave the doors open. Ventilate
the room thoroughly to accelerate the
process.
2. When defrosting is completed, clean your
freezer as described above.
Warning!
Do not use sharp objects to remove frost
from the freezer compartment. Only after
the interior is completely dry should the
appliance be switched back on and plugged
back into the main socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick to
the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on
Replacing the LED light
Warning: The LED light must be replaced by
a competent person. If the LED light is
damaged, follow the steps below:
1. Unplug your appliance.
2. Remove light cover by rising up and
pulling out the LED light.
3. Hold the LED light with one hand and pull
it with the other hand while pressing the
connector latch.
4. Replace LED light and snap it correctly in
place and recover the light cover.