Advertisement
Available languages
Available languages
ENglIsh
Fig. D4
20
Fine Adjustment (Fig. D2)
Fine adjustments are ideal for shaving small amounts from
planed material. For example, if your planed workpiece is
77.5 mm and should be 76.0 mm, proceed as follows:
1. Turn the circular label
the arrow
22
. Do not make any other adjustments.
2. Turn the depth adjustment handle
the 1.5 mm mark aligns with the arrow.
3. Plane your workpiece. The final thickness is now
76.0 mm.
Depth Stop (Fig. A, D3, D5)
The depth stop
14
(Fig. A) can be used for repetitive
planing of preset depths. Stops are set at 0, 6, 12 and
19 mm.
Use the 0 mm stop for cutting depths between 3.2
and 6 mm (Fig. D5).
1. Turn the depth stop until the desired measurement
is indicated.
2. Unlock the head lock lever
depth adjustment handle clockwise until it contacts the
depth stop. Do not turn the handle any further.
Use the 19 mm stop for other thicknesses. This will
not affect the other depth stop settings.
1. Unlock the head lock lever
adjustment handle
3
head fully.
2. Loosen the nut
23
and adjust the depth adjustment
bolt
24
as required (Fig. D5).
3. Turn the depth adjustment handle until it contacts the
depth stop. Do not turn the handle any further.
4. Plane your workpiece and check its thickness. Make
additional adjustments if required.
Fig. D5
24
23
26
21
until the 0 mark aligns with
clockwise until
3
2
(Fig. D3) and turn the
and turn the depth
2
counterclockwise to raise the
Calibrating the Depth Adjustment Scale
(Fig. D3)
The depth adjustment scale
of extended use, it is recommended to check the scale
for accuracy.
Plane a piece of wood, noting the measurement on the
9
depth adjustment scale
If adjustment is required, proceed as follows:
1. Loosen the screws
2. Adjust the indicator
finished thickness of the workpiece.
3. Firmly tighten the screws
Consult your dealer for further information on the
appropriate accessories.
Changing Blades (Fig. A, E1–E5)
Your DW733 is equipped with a cutterhead which holds
two blades.
WARNING: Sharp edges.
WARNING: The blades can be re-sharpened max.
3 mm down from their original size. If the blade size
has decreased by more than 3 mm, the blades have to
be replaced. The blades can be re-sharpened at 42°.
Fig. E1
25
39
13
Fig. E2
Fig. E3
8
is factory set. In the case
.
8
.
33
34
until its reading matches the
.
33
26
28
12
29
Advertisement
