Advertisement
Available languages
Available languages
WARNING: The machine must be level and stable at
all times.
Fig. B
15
6
Table Extensions (Fig. C1–C3)
1. Fold down the table extensions
2. The outside edges of the extension tables are level
with the base while the inside edges (closest to the
cutterhead) are below the edge of the base (Fig. C2).
3. If adjustment is required, proceed as follows: slacken
the nuts
18
and adjust the bolts
level (Fig. C2).
Fig. C1
5
Fig. C2
Fig. C3
19
18
Depth Adjustment (Fig. A, D1–D4)
To Attach the Depth Adjustment Handle
(Fig. D1)
1. Insert the depth adjustment handle
2. Secure the depth adjustment handle in place with the
hex screw and hex wrench provided.
5
and
10
(Fig. C1).
19
until the tables are
3
17
16
10
over the shaft.
3
Your DW733 is equipped with a high precision depth
adjustment system including a depth adjustment scale
(Fig. D3), a material removal scale
and a depth stop
14
(Fig. A).
3. Unlock the head lock lever
4. To attach the depth adjustment handle
One turn corresponds to a change in cutting depth of
approx. 1.5 mm.
-
Turn clockwise to decrease the cutting depth.
-
Turn counterclockwise to increase the cutting depth
(Fig. D2).
5. Read the finished thickness of your workpiece on the
depth adjustment scale
6. Make sure the material is under the material removal
gauge
20
. Read the amount of wood being removed
on the material removal scale
7. Lock the head lock lever
Fig. D1
Fig. D2
22
21
Fig. D3
2
33
ENglIsh
9
(Fig. D4), a fine adjuster
(Fig. D3) by pulling it up.
2
3
(Fig. D1).
(Fig. D3).
8
9
(Fig. D4).
(Fig. D3).
2
8
3
3
8
34
25
Advertisement
