K EE P T H IS IN S T R U C T I ON B O O KL E T F O R F U T U R E R E F E R E N CE
Important: Santec reserves the right to request additional documents b e f o r e
s e rv i c in g w a r r an t y requ es ts .
0 1
E-S ERI E S S ERI E S
L I Z A CO L LE CTI O N
In stal lati on In stru cti on s
2 4" T O WEL BAR
MO DEL : 5 16 1L Z
1.
2.
Place the trim parts against the assigned wall location. Make sure the bar is leveled and the bar post
positions are correct. Mark with pencil the bar post flange positions and remove the trims.
bar post
Using the Allen key provided, remove the holder post from the mounting post. Press the mounting post
against marked post position on the wall and mark the screw hole positions.
NOTE: MAKE SURE THE ALLEN SCREW HOLE ON THE MOUNTING POST IS FACING DOWN
WHEN SECURING TO WALL.
INSTALLING ON WOODEN SURFACE
For wooden surface, the mounting post can be
secured by screwing the screws directly into the wall.
INSTALLING ONTO DRYWALL SURFACE
Using a drill, pre-drill holes for the anchors. Insert the
anchors into the wall. The mounting post can be
secured by screwing the screws into the anchors.
INSTALLING ONTO A SOLID SURFACE
Measure the dimensions carefully.
Using a drill,
pre-drill the holes.
Secure the mounting post by
screwing the screws into the wall.
WALL
holder post mark
mounting post
0 2