Table of Contents
Advertisement
The maximum boiler water supply temperature to the indirect heat
exchanger must NOT exceed 240°F (115°C).
Insulation blankets are not required for this water heater. This
water heater meets or exceeds the ASHRAE/IES 90.1b standards
with respect to insulation and standby loss requirements.
The equipment must be installed in accordance with those installation
regulations required in the area where the installation is to be made.
These regulations must be carefully followed in all cases. Authorities
having jurisdiction shall be consulted before installations are made.
All wiring on water heaters installed in the USA must be in accordance
with the National Electrical Code and/or local regulations; or in Canada,
installed in accordance with the Canadian Electrical Code and/or local
regulations.
The following terms are used throughout this manual to bring attention to the
presence of hazards of various risk levels, or to important information
concerning product life.
DANGER
Indicates an imminently
hazardous situation, which,
if not avoided, will result in
death, serious injury, or
substantial property
damage.
WARNING
Indicates a potentially
hazardous situation, which,
if not avoided, could result
in death, serious injury, or
substantial property
damage.
CAUTION
NOTICE
SECTION I
IMPORTANT INFORMATION
-READ CAREFULLY-
CAUTION
Indicates a potentially
hazardous situation, which,
if not avoided, may result in
moderate, or minor injury or
property damage.
NOTICE
Indicates special
instructions on installation,
operation or maintenance,
which are important but not
related to personal injury
hazards.
3
Advertisement
Table of Contents
