Makita DUA251 Instruction Manual page 15

3. Remove the caps from the angled attachment.
Fig.24
► 1. Cap
4. Align the hole on the pipe with that on the attach-
ment, and then insert the pipe into the attachment.
1
3
Fig.25
► 1. Hole 2. Bolt 3. Pipe
5. Tighten 2 bolts to fix the attachment.
1
Fig.26
► 1. Bolt
1
2
15 ENGLISH
6. Attach the head of the tool to the attachment.
To fix the head of the tool vertically, fix the attachment
by tightening the bolt to the hole on the attachment
shown in the figure, and then tighten the other bolt.
Fig.27
► 1. Bolt 2. Hole
To fix the head of the tool horizontally, fix the attachment
by tightening the bolt to the hole on the attachment
shown in the figure, and then tighten the other bolt.
1
Fig.28
► 1. Bolt 2. Hole
1
2
2