GE GXRTQR Installation Instructions

Your new GE icemaker water filter comes complete with all the necessary hardware for installation.
Each filter gives you up to six months of great-tasting water. Filter should be changed after 6 months of use.
REQUIRED TOOLS FOR INSTALLATION
• a tube cutter
• 7/16" and 1/2" wrenches
• a knife
• a bucket or pan
CAUTION: Using pliers or vise grips WILL damage the fittings.
Do not use where water is microbiologically unsafe or
with water of unknown quality without adequate
disinfection before or after the filter.
WARNING
Small parts remaining after the installation could be
a choke hazard. Discard safely
• This System has been tested according to ANSI/NSF 42 for reduction of the substances listed below. The concentration of the indicated substances in water entering
the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in ANSI/NSF 42.
• Actual performance may vary with local water conditions.
Service Service
Model Flow rate
GXRTQ 0.5 gpm 2000 gal. (7571 liters)
GXRTQR (1.9 lpm) or 6 months
Testing parameters: Influent Challenges = pH 7.5 ± 0.5; Temperature 68°F ± 5°F (20°C ± 3°C); Pressure 60 psig; Flow Rate = 1gpm
If slow water or hollow ice occurs, replace filter.
• Protect from freezing. Drain filter when room temperature drops below 32°F. (0°C.).
• Use the in-line water filtering system on a potable, safe-to-drink, home COLD water supply only. The filter
will not make unsafe water safe to drink. Do NOT use on HOT water (100°F. max.).
• Do not install on line pressure above 125 psi (862 kPa), or below 25 psi (172 kPa).
• All of the refrigerator installation requirements must be met when installing the filter.
• Do not install in direct sunlight.
• Installation must comply with existing state or local plumbing codes.
• It is essential that operational, maintenance and filter replacement requirements be carried out for this product to perform as advertised.
Change filter at least every six months. Flush new cartridge for 5 minutes.
• What does this warranty cover?
— Any defect in materials or workmanship in the manufactured product.
• What does this warranty not cover?
— Filter Cartridges.
— Service trips to your home to teach you how to use the product.
— Improper installation.
— Failure of the product if it is abused, misused, altered or used for other
than the intended purpose.
— Defects that result from improper installation or damage not caused by GE.
— Liability on the part of GE under this or any other warranty for any
indirect or consequential damage.
— Products that are used for commercial or industrial applications.
— Use of this product where water is microbiologically unsafe or of unknown
quality, without adequate disinfection before or after the system. Systems
certified for cyst reduction may be used on disinfected water that may
contain filterable cysts.
GE SmartWater

INSTALLATION INSTRUCTIONS

GE Model GXRTQ and GXRTQR Filters
.
Life Pressure
25–125 psi
(172–862 kPa)
INSTALLATION PRECAUTIONS
147099 251B6017P005 (08-05 JR) 49-50073-2
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
OPTIONAL TOOLS FOR INSTALLATION
• a file
• sandpaper
SPECIFICATIONS
Max.
Temp. Contaminant % Reduction
100°F. Chlorine
(38°C.)
LIMITED 60 DAY WARRANTY
— Damage to the product caused by accident, fire, floods or acts of God.
— Incidental or consequential damage caused by possible defects with this
appliance, its installation or repair.
• For how long after the original purchase?
— Sixty (60) days.
• How do I make a warranty claim?
— Return to the retailer from which it was purchased, along with a copy of
the "Proof of Purchase." This warranty excludes the cost of shipping or
service calls to your home.
• How does state law relate to this warranty?
— This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state. THIS WARRANTY IS INTENDED
TO BE IN LIEU OF ALL OTHER WARRANTIES, WHETHER EXPRESS
OR IMPLIED, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Contact us at ge.com, or call 800.GE.CARES (800.432.2737) in the U.S., or toll-free
866.777.7627 in Canada.
ge.com
™
System tested and certified by NSF international
against ANSI/NSF Std. 42 for the reduction of
chlorine and taste and odor.
Tested % Reduction Influent Challenge
Required Concn. Required
≥75%
93% 2.0 mg/L ± 10%
Average Average
Influent Effluent
2.0 mg/L 0.1 mg/L