Power On Your Phone; Power Off Your Phone - Alcatel 1060D Quick Start Manual

2
Getting started
2.1 Set-up
Removing and installing the back cover
Removing and installing the battery
Inserting and removing SIM1
Inserting and removing SIM2
Place the SIM card with the chip facing downwards and slide it
into its housing. Make sure that it is correctly inserted. To
remove the card, push it and slide it out.
ALCATEL 1060D, two SIM cards can be inserted.
SIM1, is for SIM2.
2
IP4632_ALCATEL 1060D_QG_Eng_GB_05_130520.indd 5-6 IP4632_ALCATEL 1060D_QG_Eng_GB_05_130520.indd 5-6
Inserting and removing the TF card
............
Charging the battery
Connect the battery charger to your phone and mains socket
respectively.
• The charging may take about 20 minutes to start if the
battery is flat.
• Be careful not to force the plug into the socket.
• Make sure the battery is correctly inserted before
1
connecting the charger.
• The mains socket must be near to the phone and easily
accessible (avoid electric extension cables).
• When using your telephone for the first time, charge the
battery fully (approximately 3 hours). You are advised to
fully charge the battery (
• To reduce power consumption and energy waste, when
2
battery is fully charged, disconnect your charger from the
plug; reduce the backlight time, etc.
2.2
Hold down the
is for
1
2.3
Hold down the
5
).
The charge is complete when the animation stops.

Power on your phone

key until the phone powers on.

Power off your phone

key from the idle screen.
6
2013-5-20 16:44:15 2013-5-20 16:44:15