Fuel; Oil / Changing Oil - Texas A/S POWER LINE TG 622 Instruction Manual

5. Fuel

Don't overfill the capacity of the fuel tank The indicator on the tank shows how much fuel is left
See fig 7
TG620 / TG622 / TG720 / TG722

6. Oil / changing oil

•
Always check the oil level when the engine is placed in a horizontal position.
•
Always check the oil level visible and to edge of fill hole
See fig. 5.
TG620 / TG622 / TG720 / TG722
Change the oil according to the specifications of the machine.
1. Let the engine run 5 minutes, so the engine is hot.
Warm oil liquefies, which makes it easier to drain the oil.
2. Unscrew the drain plug (Fig 6.1) and let the warm oil run out of the engine.
Remember to keep an appropriate container ready.
3. Attach the drain plug and fasten.
Refilling oil (Fig 5)
1. Remove the oil filler cap
2. Refill the oil to the edge of the filling hole (see capacity above)
Important: Before changing oil, ensure that the engine is level position.
Important: By the right amount oil the oil MUST be visible and to edge of fill hole
Please dispose the used engine oil environmentally correct. We suggest that you keep the used
oil in a sealed container and dispose at your recycling center or service station for reclamation. Do
not throw it in the waste; pour it on the ground; or down a drain.
Only use unleaded fuel octane 95 on your engine.
Use the correct oil for the specific time of year.
SAE 30 or 10W-40
SAE 30 Art.no 90406500
OIL CAPACITY
CHANGING OIL
FUEL
OIL
13
3,6 Litre
0.6 Litre