Page 1
GRUNDFOS INSTRUCTIONS 50/60 Hz Service instructions AMG 50/60 Hz Installation and operating instructions Other languages http://net.grundfos.com/qr/i/97908898...
Page 3
English (US) Service instructions ............... . 4...
Work in or near pits must be carried out according to local cannot roll of fall over. regulations. See the installation and operating instructions for mixers, type AMG DANGER (96498078). Use the QR code and the link on the front of this document.
‐ Maintenance and service work on explosion-proof Disconnect the power cable in accordance with local regulations. products must be carried out by Grundfos or a service workshop authorised by Grundfos. WARNING Related information Rotating blades 4.2 Special tools...
Page 7
3.3.3 Removing the gear casing motor. 3.3.7 Removing the stator AMG.20-55 [ANSI] and AMG.15-40 [DIN] 3.3.5 Removing the cable 1. Remove the nut (1158), spring washer (1045) and screw (1044) 1. Place the motor in horizontal position with the terminal box from the terminal box inside the motor housing (1017) and mark upwards.
Tap gently, if needed. Maintenance and service work on explosion-proof products must be carried out by Grundfos or a service 10. Lubricate the groove for the O-ring (1022) on the gear side of workshop authorised by Grundfos.
Page 9
3.4.2 Fitting the cable 3.4.4 Fitting the gear casing 1. Place the motor in horizontal position. Lubricate and tighten the screws and nuts according to 2. Fit the cable flange (1002) and the O-ring (1007) on the cable section Torques and lubricants.
Page 10
3.4.5 Fitting the sealing system of propeller hub and gear 32. Fit and tighten the plug (1102) in the gear casing (1088). casing 33. Apply a new coat of paint if the coat is damaged. Related information Lubricate and tighten the screws and nuts according to 4.1 Oil types and quantity section Torques and...
Page 20
4.4.3 Components and material specification DIN W.-Nr. / DIN W.-Nr. / Pos. Component Material AISI/ASTM Pos. Component Material AISI/ASTM EN standard EN standard 1001 Cable CPE (rubber) Carbon/Alox/ 1048* Shaft seal EN-GJL250/ Cast iron/ A48 class 1002 Cable flange Stainless steel 35/316L 1.4404 Brass/...
DIN W.-Nr. / Pos. Component Material AISI/ASTM EN standard DIN 1.4301/ 1111 Screw DIN 1.4401 1119 PTFE tape PTFE 1156 Washer Ck45N DIN 1.1191 1158 Zinc-plated steel 1173 Seal washer Copper * Only in explosion-proof versions. 5. Document quality feedback To provide feedback about this document, scan the QR code using your phone’s camera or a QR code app.
Page 22
Fax: +36-23 511 111 Albany, Auckland Tel.: +64-9-415 3240 Turkey Canada India Fax: +64-9-415 3250 GRUNDFOS POMPA San. ve Tic. Ltd. Sti. GRUNDFOS Canada inc. GRUNDFOS Pumps india Private Limited Gebze Organize Sanayi Bölgesi Norway 2941 Brighton Road 118 Old Mahabalipuram Road...