Network Setup - Philips BDP7500 MK II User Manual

5
Select a setting, and press OK.
To return to the previous menu, press
.
To exit the menu, press
Increase a soft sound level such as dialogue to
make it easier to hear at a low volume, while
simultaneously decreasing a loud sound level.
- Detect and select a best sound level
at a low volume. Applicable to tracks with
Dolby TrueHD audio only.
– For quiet viewing at night.
– For surround sound with a full dynamic
range.
Note
Applicable only to Dolby encoded DVD-video or BD-
video.
A post processing by DTS to generate a surround
sound effect from 2 channel audio.
– Enable Neo 6 post processing to
the cinema mode.
- Enable Neo 6 post processing to the
music mode.
– Disable Neo 6 post processing.
Select an HDMI audio output when you connect
this product and the TV/audio device with an HDMI
cable.
– Select the best original HD
audio experience (only via an HD audio
compatible receiver).
– Detect and select the best supported
audio format automatically.
Select an audio format for the sound output from
the DIGITAL OUT jack (coaxial/optical).
- Detect and select the best supported
audio format automatically.
- The audio device does not support
multi-channel format. Audio is downmixed to
two-channel sound.
- Select the original audio to
experience Dolby or DTS audio (BD-video
special sound effect is disabled).
Note
Ensure that the audio format is supported by the disc
When is selected, interactive audio like
button sound is muted.
Set the sampling rate for PCM audio output from
the DIGITAL OUT jack (coaxial/optical).
.
Optimize the surround output for the connected
speaker system.

Network setup

1
2
3
- PCM audio is down-sampled at 48kHz.
- For BD or DVD recorded in LPCM
without copyright protection, two-channel
audio signals up to 96 kHz are output as LPCM
signals with no conversion.
- Activate the test tone for
the speakers and the subwoofer.
- Set the delay time for
the speakers and the subwoofer if they are
placed closer to the listening position, so that
the sound output from all speakers reach the
listening position at the same time.
- Set the volume level of
the speakes and the subwoofer to get the ideal
audio balance.
Set the speaker size for the speakers and
the subwoofer.
Select size for speakers that can
produce low frequency signal below 120 Hz.
Select if there is no speaker
connected.
If the front speakers are set to
subwoofer setting is
be changed.
If the subwoofer is set to
front speakers settings are
cannot be changed.
Tip
The test tone is emitted from the speaker while adjusting
the volume level.
Allow 1ms setting for every 30cm distance between the
speaker and the listening position.
Press .
Select , and press OK.
Select
,
and it cannot
, the
and it
, and press .
EN 21