Other Features; Audio Control Setting; Clock Display; Adjusting Time - Kenwood KRC-177RA Instruction Manual

Other features

(See page 7)

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode
display changes as follows:
7 Bass 7 Treble 7 Balance 7 Fader 7 Volume
If you do not move to step 2 in 5 seconds, the unit will switch
back to the volume adjustment mode (i.e., the normal mode).
NOTE
Source tone memory
Each source (tape, FM, AM) has its own memory in which to
store the bass and treble tone settings.
The settings made for a particular source are then recalled auto-
matically whenever you use that source (e.g., FM mode uses the
tone settings made for FM, AM for AM, etc.).
2
Press the d/u buttons to adjust the mode shown in the dis-
play.
Use the following table as a guide for adjusting the settings in
each mode.
Adjustment
Operation of Audio control button
mode
d button
(Display)
Bass
Bass decreased.
("BAS")
Treble
Treble decreased.
("TRE")
Balance Left channel empha-
("BAL") sized.
Fader Rear channel
("FAD") increased.

Clock Display

Display the time.
Switching to Time Display:
Press the CLK button repeatedly until the clock is displayed.
u button
Bass increased.
Treble increased.
Right channel empha-
sized.
Front channel
increased.
— 17 —

Adjusting Time

When the RDS station tuned into is transmitting a time signal,
have the unit's built-in time adjust automatically to the cor-
rect local time.
Adjusting the Time:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
NOTE
• The displayed time cannot be set manually, but only through
RDS station time signals.
• The time is not adjusted when the RDS station you are tuned to
is not transmitting a time signal. Choose another RDS station in
such a case.

TEL Mute Function

Shut down the audio system temporarily whenever an incom-
ing call is received.
NOTE
The function will not work if a cable is not connected to the car
phone.
When the telephone rings:
When a call is received, "CALL" is displayed and all the unit
functions are temporarily interrupted.
Restoring Original Unit Source During Phone Call:
Press the SRC button.
"CALL" disappears from the display, and the volume of the orig-
inal source is restored gradually.
Turning TEL Mute Function Off After Phone Call:
Hang the phone up.
"CALL" disappears from the display.
The original source (i.e., the one used before the phone call) is
returned to automatically, and the volume restored gradually.