Kenwood KRC-177RA Instruction Manual page 22

Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
2
When the lower level is removed, remove the upper two loca-
tions.
NOTE
The frame can be removed from the top side in the same man-
ner.
Catch
Lock
— 22 —
Removing the Unit
1
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
2
Remove the screw (M4 8) on the back panel.
3
Insert the two removal tools deeply into the slots on each side,
as shown.
Screw (M4X8)
(commercially
available)
4
Lower the removal tool
toward the bottom, and pull
out the unit halfway whilst
pressing towards the
inside.
2CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5
Pull the unit all the way out
with your hands, being care-
ful not to drop it.
Catch facing up