Installing The I/O Daughter-Board Cable - Dell Inspiron 14 5435 Owner's Manual

Steps
1. Peel back the tape that secures the I/O daughter-board cable to the fan.
2. Peel back the tape that secures the I/O daughter-board cable to the connector on the system board.
3. Open the latch and disconnect the I/O daughter-board cable from the connector on the system board.
4. Carefully unroute the I/O daughter-board cable from the routing guides on palm-rest and keyboard assembly.
5. Peel back the tape that secures the I/O daughter-board cable to the connector on the I/O daughter-board.
6. Open the latch and disconnect the I/O daughter-board cable from the connector on the I/O daughter-board.
7. Lift the I/O daughter-board cable off the palm-rest and keyboard assembly.

Installing the I/O daughter-board cable

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the I/O daughter-board cable and provide a visual representation of the installation
procedure.
62 Removing and installing Field Replaceable Units (FRUs)