Manual Tune; First Time Installation - Sharp TU-T2 Operation Manual

Basic adjustment
Manually tuning channels
General

Manual tune

You can manually tune new services after the first time
installation has been completed.
Manual Tune
UHF Channel 42
Frequency (kHz) 641787
Bandwidth 8MHz
System DVBT
Mode 2K Guard 1/32
FEC 3/4 Mod QAM16
NID ==== TSID ====
Systems Found / Added == / ==
Tuner Lock Lock
Signal Strength
Signal Quality
OK Exit
Watch Exit Menu Start Scan
You can manually tune new services after the first time
installation has been completed.
1 c/d
Press to select the desired UHF channel.
2 b
Press to select 'Frequency (kHz).
3
c/d
Press to adjust the frequency.
4 b
Press to select 'Bandwidth'.
5
c/d
Press to adjust the 'bandwidth'
6 b
Press to select 'System.
7 c/d
Press to select a 'System'.
8
Press the blue coloured button to start
scanning for the specified channel. If the
channel is found it will be stored in the
Receiver and will be available in the channel
list and EPG.
The channel number you want to save
UHF Channel
the manually tuned channel as.
The frequency of the service (channel)
Frequency
you are manually tuning.
The bandwidth of the service (channel)
Bandwidth
you are manually tuning.
The type of tuning system
System
NOTE
You can enter the UHF Channel and Frequency using the 0-9
•
numeric buttons.
General

First time installation

This function allows you to perform a first time installation
(page 9).
22
TU-T2_GB.indd 22 TU-T2_GB.indd 22
19%
40%
Item
01/06/2010 16:03:14 01/06/2010 16:03:14