PDP REALMz Quick Start Manual page 3

5. Mic Mute
To mute your headset's mic, press the "function" button twice. The LED on the "function" button will turn on to indicate that you are now muted. To
unmute, press the "function" button twice again.
6. Programming the Back Buttons
A. While holding down the "function" button, press the back button you would like to map a function to and release. The function button LED will
start flashing.
B. Press any button you would like mapped, and the function button LED will flash 3 times indicating a successfully mapped function.
Note: The programed button mapping will remain after unplugging the controller.
7. Change LED Lighting Modes
A. The REALMz™ Wired Controller comes with four different lighting effects pre-programmed to the controller's A, B, X, and Y buttons.
B. To explore these effects and cycle through them, hold the "function" button and press either A, B, X, or Y.
Note: When the controller and system turn off, the lighting modes reset to the default mode (the mode for the A button).
8. Adjusting LED Light Settings
A. To adjust the LED brightness, hold the "function" button and press LB to decrease brightness, or RB to increase brightness.