Drive Bay Installation/Removal; Accessing The Drive Bays - Supero AS-2021M-32R User Manual

AS2021M-32R User's Manual
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays

SAS Drives: You do not need to access the inside of the chassis or remove power
to replace or swap SAS drives. Proceed to the next step for instructions.
Note: You must use standard 1" high, SAS drives in the 2021M-32R.
DVD-ROM/Floppy Disk Drive: For installing/removing a DVD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the server by removing the top
cover of the chassis. Proceed to the "DVD-ROM and Floppy Drive Installation"
section later in this chapter for instructions.
5.25" Drive Bay: For installing/removing a component in the 5.25" drive bay, proceed
to the "5.25" Drive Bay Installation" section later in this chapter for instructions.
Removing the Air Shroud
Under most circumstances you will not need to remove the air shroud to perform
any service on the system. However, if you wish to temporarily remove it (the air
shroud sould always be in place when the system is operating), please follow this
procedure.
Figure 6-2. Removing System Cooling Fans
6-4