Steps
1. Locate the touchpad buttons slot on your computer.
2. Align and place the touchpad buttons into the slot on your computer.
3. Connect the touchpad buttons cable to the connector on the computer and secure the latch.
4. Install the two (M2x3) screws to secure the touchpad buttons on to the computer.
5. Connect the smart card reader cable to its connector and secure the latch.
Next steps
1. Install the
inner
frame.
2. Install the
WWAN
card.
3. Install the
WLAN
card.
4. Install the HDD.
5. Install the
solid state
drive.
6. Install the battery.
7. Install the
base
cover.
8. Follow the procedure in
SmartCard reader
Removing the smart card reader board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
After working inside your
computer.
Before working inside your
computer.
Disassembly and reassembly
47