Skil OS5937-00 Owner's Manual page 13

LED Light
Your tool is equipped with two LED lights,
located on the head of the tool. This provides
additional light on the surface of the work piece
for operation in lower-light areas.
The LED light will automatically turn on when
the on/off switch is in "ON" position, and off
when the on/off switch is in "OFF" position.
(Fig.5)
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off, and the LED lights will flash
rapidly to indicate the over-load or
over-temperature condition.
Rest the tool for a while or place the tool and battery pack separately under air flow to cool.
Installing and Removing Accessories
WARNING
WARNING
can cause personal injury.
WARNING
and cause a hazard.
Always turn the tool off and remove the battery pack before assembling
parts.
Wear protective gloves when changing accessories. Accessories
become hot after prolonged use. And the sharp edges of the accessories
Check that the accessories are correctly attached. Incorrect or
insecurely attached accessories can come loose during operation
Fig.5
LED Lights
13