Table of Contents
Advertisement
What You Will Need
¼ in. outer diameter, to
y
Copper Tubing,
connect the fridge to the water supply.
Be sure both ends of the tubing are cut
square.
To determine how much
y
tubing you need: measure
the distance from the
water valve on the back of the fridge to the
water supply pipe. Then, add 8 feet (2.4
m). Be sure there is sufficient extra tubing
(about 8 feet [2.4 m] coiled into 3 turns
of about 10 in. [25 cm] diameter) to allow
the fridge to move out from the wall after
installation.
y
Power drill.
½ in. or adjustable
y
wrench.
y
Flat blade and Phillips
head screwdrivers.
y
Two ¼ in. outer diameter
compression nuts and
2 ferrules (sleeves) to
connect the copper tubing to the shutoff
valve and the fridge water valve.
If your existing copper water line has a
y
flared fitting at the end, you will need
an adapter (available at plumbing supply
stores) to connect the water line to the
fridge OR you can
cut off the flared
fitting with a tube
cutter and then use a
compression fitting.
y
Shutoff valve to connect to the cold water line.
The shutoff valve should have a water inlet
with a minimum inside diameter of 5/32
in. at the point of connection to the COLD
WATER LINE. Saddle-type shutoff valves
are included in many water supply kits.
Before purchasing,
make sure a saddle-
type valve complies
with your local
plumbing codes.
NOTE
A self piercing saddle type water valve
should not be used.
Water Line Installation Instructions
WARNING
When using any electrical device
(such as a power drill) during
installation, be sure the device is
battery powered, double insulated
or grounded in a manner that will
prevent the hazard of electric shock.
Install the shutoff valve on the nearest
frequently used drinking water line.
1
SHUT OFF THE MAIN WATER SUPPLY
Turn on the nearest faucet to relieve the
pressure on the line.
2
CHOOSE THE VALVE LOCATION
Choose a location for
the valve that is easily
accessible. It is best to
connect into the side of a
vertical water pipe. When
it is necessary to connect
into a horizontal water
pipe, make the connection to the top or
side, rather than at the bottom, to avoid
drawing off any sediment from the water
pipe.
3
DRILL THE HOLE FOR THE VALVE
Drill a ¼ in. hole in
the water pipe using
a sharp bit. Remove
any burrs resulting
from drilling the hole
in the pipe. Be careful
not to allow water
to drain into the drill. Failure to drill a ¼ in.
hole may result in reduced ice production
or smaller cubes.
NOTE
The hookup line cannot be white, plastic
tubing. Licensed plumbers must use
only copper tubing NDA tubing #49595
or 49599 or Cross Link Polyethylene
(PEX) tubing.
INSTALLATION
19
Advertisement
Table of Contents
