Installation - Bimar ECOPANEL S580.EU Instruction Booklet

Fax +32 030 9904733
I
•
f fixed in
to be installed so that switches and other controls cannot be touched by a person in the bath or
shower.
T
•
he appliance must not be positioned immediately under a socket.
D
•
o not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.

INSTALLATION

• After removing the packing materials, check the integrity of the heater; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity. In the event of incompatibility between the electric outlet and the plug of the
heater, have the outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is appropriate for the
absorbed power of the heater. Check that the mains are not connected equipment; high absorption
to prevent overloading and fire risks. Check that the mains are not connected equipment; high
absorption to prevent overloading and fire risks. In general, the use of adapters or extension cords
is not recommended; if their use is indispensable, they must conform to existing safety standards
and their current capacity (amperes) must not be less that the maximum of the heater.Attention:
before use the appliance remove the detachable coupon.
• The appliance can be used when attached to the wall (in fixed position), the surface must be flat,
without bumps, very stable and resistant to heat (Do not place or pull the panel on the floor) or used
on the floor through the food supplied.
• Position the appliance far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat. Make sure that there is 100 cm of free space in front of the appliance and 50 cm
on the sides.
• Do not use the heater in places where it could be subject to shocks in the immediate vicinity of a
bathtub, shower or swimming pool to avoid drops of water falling on the heater or the heater falling
in the water: If the appliance should accidentally get wet or be submerged in water, remove the
plug from the supply socket immediately and dry the unit carefully. Check that no liquid has gone
inside and if in doubt, contact professionally qualified personnel.
Portable installation
In order to use the appliance the two feet supplied must be fitted to the same by operating as follows:
- Always unplug the appliance before you assemble.
- Put the appliance down horizontally on a flat, smooth surface.
- Put the free standing feet onto ground, keep the slots of both foot
from either side to the relevant foot is recommended; then insert the panel into the slots lightly.
- Screw the two bolts into the holes on the feet
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
a bathroom shall
9/28
Assembly page 9/28
state that the heater
collinear, distance as 5-7cm
is