Table of Contents
Advertisement
aus
Operating the appliance
Switching off automatically
after the end of
the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
can be adjusted from ˜:‹‹ to ˜:‹ƒ.
Automatic disconnection
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button P
until š:‹... is indicated on the digital
display.
4. Release both buttons.
5. Press programme button # until
the factory set value ˜:‹‚
is indicated on the digital
display h.
To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
when the value of ˜:‹ƒ has been
set value increases by one level;
to ˜:‹‹ (off).
reached, the display jumps back
2. Press START button P.
The set value is saved.
22
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
Switching off the appliance
Short time after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off the tap (not applicable if
Aqua-Stop fitted).
3. Open the door.
4. Remove the utensils when they have
cooled down.
Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.
Interrupting the programme
1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch ( again.
Advertisement
Table of Contents
