Frigidaire LFHB2741PF Use & Care Manual page 19

Options May Vary
options Used to enter and exit the
(∧ or ∨) options menu and make
selections.
exit
Toggles the options and run
modes.
control While in the locked state, you
locked
will not be able to change any
settings on the display nor
dispense ice and water. The
"Control Locked" indicator will
flash and an audible warning
tone is played.
quick
Activates a faster rate for
freeze on
freezing food and increases
off
ice production in the freezer.
Deactivates after 12 hours.
ice maker Toggles the ice maker in the
on off
refrigerator compartment "ON"
or "OFF". In the "Off" state, the
indicator will blink when ice is
dispensed.
display Toggles the temperature
on off
displays On and Off.
refrigerator
Allows the temperature set-
temp
points to be adjusted. Control
temperatures range from +33°F
/ +1°C to +47°F / +8°C.
freezer
Allows the temperature set-
temp
points to be adjusted. Control
temperatures range from -6°F /
-21°C to +6°F / -15°C.
mode Toggles display from Fahrenheit
°F °C
to Celsius.
light
Toggles dispenser light On and
Off.
power off Press and hold for three seconds
to turn off the cooling system.
It also turns off the ice maker
and all dispenser functions. The
display will read "power off".
water filter Displays the current status of
the water filter (Good, Order,
or Replace). To reset the filter
status to "Good", press and hold
the "set" key for three seconds.
air filter
Displays the current status of
the air filter (Good, Order, or
Replace). To reset the filter
status to "Good", press and hold
the "set" key for three seconds.
default
While in the default option,
settings
press and hold the set key
for three seconds to reset all
refrigerator settings to their
factory default settings.
set (+ or -)
Selects the current menu
selection option.
water Press the "water" key to select
water. A green indicator light will
be illuminated above the active
feature.
cube
Press the "cube" key to select
cubed ice. A green indicator
light will be illuminated above
the active feature.
crush
Press the "crush" key to select
crushed ice. A green indicator
light will be illuminated above
the active feature.
Setting cooling temperatures
(options may vary)

NOTE
When you first power on the refrigerator, the
temperature displays 0°F and 37°F. After a
few seconds, both of the displays will switch to
"HI". The displays will continue to show "HI" for
20 minutes. After 20 minutes, the High Temp
alarm will sound and both displays will show
the actual temperature.
1 Plus (+) and Minus (-) indicators are located
on the right side of the control panel.
2 Press the + or - indicator to adjust the
temperature to the desired setting.
CONTROLS
19