Installing Door Handles - Frigidaire LFHB2741PF Use & Care Manual

Hide thumbs

Table of Contents

Door Handle Mounting

Instructions for Frigidaire

1 Remove handles from carton and

any other protective packaging.

2 Position fresh food handle end caps

over upper and lower pre-installed

shoulder bolts (A) that are fastened

into door, ensuring the holes for the

set screws are facing towards the

opposite door.

3 While holding handle firmly against

door, fasten upper and lower Allen set

screws (B) with supplied Allen wrench.

4 Repeat steps 2 and 3 to install

opposite handle. Ensure the holes

for the set screws are facing

towards the first door.

5 Position freezer handle end caps

over left and right pre-installed

shoulder bolts that are fastened to

the door, ensuring the holes for the

set screws are facing down.

6 While holding handle firmly against

door, loosely tighten right Allen

set screw (B) with supplied Allen

wrench until there is no gap

between handle and door.

7 Still holding the handle firmly to the

door, firmly tighten left Allen set

screw (B) with supplied Allen wrench.

8 Return to the right Allen set screw

(B) and firmly tighten with supplied

Allen wrench.



NOTE

All set screws should be tightened so the screw is below the surface of the handle. The handles

should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door

while tightening the Allen screw makes installation easier.

The door handle may loosen over time or if it was installed improperly. If this happens, tighten the

set screws on the handles.

CAUTION

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.